Hoffman nvent Genesis HB16, Инструкция по эксплуатации, Страница: 11 / 18

87976428
- 10 -
HOW TO REMOVE, CLEAN OR INSTALL A
NEW FILTER
1. Lift ����� up so the bottm clears the
������� etainer.
2. Pull the bott�������������
pushing down until the top of the ���
clears the upper retainer. If the unit is
operating, carefully remove it assuring
no dirt from ����� enter the air
intake opening.
3. Follow the cleaning instructions shown
in the graphic below.
4. Look at the air ��arrows on the
��� for correct installation direction.
Reinstall ����������� a new
���� y sliding the top of ����� up
into the upper retainer while pushing it
against the unit. Finally, ��������
down into the lower retainer.
For replacement filter, disposable filters and filter adhesive, see parts list in Table 1 on page
12
1. Flush the filter with warm water from the exhaust
side to the intake side. DO NOT use caustics.
2. After flushing, allow filter to drain. Placing it with
a corner down will assure complete drainage.
3. Recoat the filters with RP Super Filter Coat
adhesive by dipping or spraying. If the filter is
sprayed, do so from both sides for maximum
concentration of adhesive.
RP aluminum washable air filters are designed to provide
excellent filtering efficiency with a high dust holding capacity
and a minimum amount of resistance to air flow. Because they
are constructed entirely of aluminum, they are light weight
and easy to service. Optimum filter performance is
maintained by recoating the filters after washing with RP
Super Filter Coat adhesive. To achieve maximum performance
from your air handling equiment, the air filter should be
cleaned on a regular basis.
C-NET INDUSTRIAL LTD. | +44(0)121 544 8608 | INFO@CNET-IS.CO.UK | WWW.CNET-IS.CO.UK