Install this product in accordance with NFPA 72, the National Electrical Code, and all local codes.
WARNING!
The module must be installed by personnel familiar with electronic components. Electronic
components within the module are vulnerable to damage from electrostatic discharge. Ground straps must be worn by
installers before handling to prevent electrostatic discharge damage.
Before You Begin
The following item is not included with the FireNET L@titude Fire Alarm Control Panel, but is required for the
installation:
l
A Ground Strap is required for handling circuit boards.
Setting the Address
Panel modules should use addresses 1-8. Each panel module of the FireNET L@titude Fire Alarm
Control Panel must contain a unique setting before being connected to the Main Back Board. The binary setting
of the DIP switch sets the specific address for the panel module. The numeric order of the address setting
between modules does not impact operation, but each panel module must be assigned a separate / unique
address.
The black portion of the DIP switch identifies the switch actuator.
Placement
To install modules on the FireNET L@titude Fire Alarm Control Panel:
Hochiki America Corporation
16 Channel IO Panel Module (S772) Information Guide
Version 1.00 | March 2021 | MAN-1420HA
Page 10
Installation
