Hochiki FirePro Xtinguish, Инструкция по установке и эксплуатации

Страница: 46 / 113

Page 46 of 113
FirePro Xtinguish I&O Manual V1.05 UL
11.4 Condensed Aerosol Generator Height Limitations
The height limitation for each specific condensed aerosol generator is reported on the condensed
aerosol generator data sheets (Appendix C).
The “Stream Length” value of each generator should be considered as the maximum height at which
it should be installed above the floor or object to protect, whenever the aerosol stream from the
generator’s outlet is vertical (at 90 degrees). Whenever a different angle is applied, then the height
should be reduced accordingly.
In multiple condensed aerosol generator installations, they shall be distributed throughout the
protected enclosure in accordance with the height limitation (coverage) of each condensed aerosol
generator.
11.5 Condensed Aerosol Generator Initiation (Activation)
The condensed aerosol generators are initiated (activated) by means of an electric impulse of:

6 - 36 Volts direct-current (DC).
The required current shall be delivered through the connector to the initiator of the condensed aerosol
generator.
The condensed aerosol generators are equipped with the Initiator described in Section 7.1.2.
The condensed aerosol generators require a minimum of 0.8 amps of activation current each. Ensure
that the necessary power is available to activate the generator(s) during an emergency condition.
11.5.1 Automatic Activation by means of a Fire Detection System
A listed and compatible fire alarm control panel may be used to automatically activate the aerosol
generator(s).