Hochiki FirePro Xtinguish, Инструкция по установке и эксплуатации

Страница: 28 / 113

Page 28 of 113
FirePro Xtinguish I&O Manual V1.05 UL
i. Provision for prompt ventilation of such areas, including forced ventilation if necessary. Use
caution to avoid spreading condensed aerosol residue to other areas.
j. Smoking should be prohibited until the atmosphere has been determined to be free from
the
FirePro Xtinguish
condensed aerosol.
k. Removal of
FirePro Xtinguish
condensed aerosol generators after discharge shall be done
according to the instructions given in this manual. Protective clothing, gloves and goggles
should be worn, including a respirator or mask if necessary.
l. Any further provision or safeguards shall be adopted if a particular situation indicates it as
necessary to prevent injury or death.
m. Specific attention shall be given to the possibility that the
FirePro Xtinguish
condensed
aerosol may potentially spread to adjacent areas outside of the protected space.
9.3 Electrical Clearances
All system components shall be located to maintain no less than minimum clearances from energized
electrical parts as per:

ANSI C2

NFPA 70

29
CFR
1910, Subpart S

Canadian Electrical Code, CSA C22.1
Where the design basic insulation level (BIL) is not available, and where nominal voltage is used for
the design criteria, the highest minimum clearance listed for this group shall be used.
The selected clearance to ground shall satisfy the greater of the switching surge or BIL duty, rather
than being based on nominal voltage.
The clearance between non insulated, energized parts of the electrical system equipment and any
portion of the
FirePro Xtinguish
condensed aerosol extinguishing system shall not be less than the
minimum clearance provided elsewhere for electrical system insulations on any individual component
9.4 Precautions While Handling the Generator Units
While handling the aerosol generators do not:

Disassemble the
FirePro Xtinguish
condensed aerosol generators.

Exert force of impact or carry out other actions to the
FirePro Xtinguish
condensed aerosol
generators which may cause distortion and physical or other mechanical damage to the casing.

Carry out any welding work in the vicinity of the
FirePro Xtinguish
condensed aerosol
generators and/or condensed aerosol fire extinguishing system components.

Smoke in the vicinity of
FirePro Xtinguish
condensed aerosol generators and/or
FirePro Xtinguish
condensed aerosol fire extinguishing system components.
Where a
FirePro Xtinguish
condensed aerosol generator, during handling or installation, is dropped
or subjected to an impact, ensure that the electric circuit of the ignition and the
other
FirePro Xtinguish
condensed aerosol generator components have not been damaged.
Where a
FirePro Xtinguish
condensed aerosol generator shows external damages to the casing it
shall not be installed.