HobbyKing DragonFly EDF Скачать руководство пользователя страница 1

Страница: 1 / 9

Assembly manual

Intended for use by intermediate fliers.

Some build experience is required.

Specifications:

Meterial:

Plywood and film covered balsa.

Wingspan:

920MM.

Length:

830MM

Flying weight: 800-900g
Motor:

2830-3600kV (Included)

EDF:

68mm (Included)

ESC:

40A (Required)

Servo:

5x9g (Required – MG90S is recommended)

Battery:

2200 mah 3S (Required)

Radio system:

4+ channel (Required)

Содержание DragonFly EDF

Страница 1: ...is required Specifications Meterial Plywood and film covered balsa Wingspan 920MM Length 830MM Flying weight 800 900g Motor 2830 3600kV Included EDF 68mm Included ESC 40A Required Servo 5x9g Required MG90S is recommended Battery 2200 mah 3S Required Radio system 4 channel Required ...

Страница 2: ... and struts Pushrods x5 Long and short CF rod pins Additional hardware screws clevises horns etc Fiberglass fin Equipment required not included 4 channel radio and receiver 5x9g servos 30 50A ESC Battery 2200mah 3S1P is recommended Strong epoxy 15 30 min and strong CA glue Velcro 30cm servo extension wires x2 2mm drill bit Small screwdrivers and Allen hex keys Craft knife ...

Страница 6: ...e landing gear strut in position Secure with the included control arm and hex screw Attach a pushrod and metal clevis Install the nose landing gear servo in the provided servo mount Make sure to mount the servo as far away from the centerline of the fuselage as possible to avoid the pushrod interfering with the battery pack ...

Страница 8: ... the covering film from the fuselage in the following locations Slide the large CF rod into one of the main wings and slide that wing in place onto the fuselage Slide on the other main wing and secure one to the other using the rubber o ring as shown You may need to adjust the eyelets to achieve the correct tension in the rubber band Locator pin Eyehook ...