super multi-rotor controller
flight mode and receiver type setup
-2-
The Super Multi-Rotor Controller supports four different flight modes and four different receiver
types. Using a toothpick or similar non-metallic instrument, adjust DIP switches 1 and 2 to choose
the flight mode that matches your multi-copter’s setup (illustrated below), then adjust DIP switches
3 and 4 to choose the receiver type that matches the receiver type you’re using. See table below.
overview and mounting
Mount the Super Multi-Rotor Controller into
your model, using the piece of double-sided
foam tape included.
Make sure that the front of the Super
Multi-Rotor Controller is orientated toward
the front of your model and that it’s mounted
on a flat, level surface, directly in the center of
center of your model.
‘+4’
‘X4’
‘HEX6’
‘X6’
Standard
S-BUS
DSM2
DSMX
White
Blue
Yellow
Purple
flight
mode
switch
position
receiver
type
led
status
switch
position
1
2
1
2
1
2
1
2
3
4
3
4
3
4
3
4
Clockwise Motor Rotation ‘R’
Counter-Clockwise Motor Rotation ‘L’
ESC3
FRONT
ESC1
ESC2
ESC4
‘X4’
ESC1
ESC2
ESC4
ESC3
‘+4’
FRONT
‘X6’
ESC1
ESC4
ESC6
ESC3
ESC5
ESC2
FRONT
ESC6
ESC3
ESC5
ESC2
ESC4
ESC1
‘HEX6’
FRONT
Setup Button
Gain Dial
DIP Switches
Status LED
DSM2/DSMX
Receiver Port
S-BUS
Receiver Port
ESC Ports
Standard Receiver Ports
TOP
Negative
Positive
Signal
Do not make any connections between your receiver or ESCs and the Super Multi-Rotor
Controller until after setting up your transmitter and calibrating the throttle control range of
each of your ESCs. For more information, see the Transmitter Setup and ESC Calibration section on
the next page.
Switch Position Indicated in Black
