Hobart WS-55, Инструкции по установке и перечень запасных частей, Страница: 3 / 16

7. Thread the brass in/out adapters tightly onto the
threaded ends of the connector hoses.
8. Install one O-Ring into each groove of the brass
adapter.
9. Apply a small amount of seal lube evenly onto
each O-ring.
10. Remove the pin and bracket from the softener
in/out port area.
11. Install the brass adapters into the in/out ports
and secure by reinstalling the bracket and pin.
NOTE: The inlet connection from the building supply
is connected to the inlet of the carbon block filter
head. The outlet from the carbon block filter head is
connected to the inlet of the softener head. The
outlet from the softener head is connected to the
device.
F25407 (February 2011) Page 3 of 16