HNC Electric HV950-1R5G1(B), Руководство пользователя

Страница: 39 / 97

39
Table 6-8 Parameter Setting and Function of Output Terminals
Setting Function Setting Function
0
Inverter running signal
（
RUN
）
1
Frequency arrival signal
（
FAR
）
2
Frequency detection
threshold
（
FDT1
）
3 Reserved
4 Reserved 5
Low voltage lock-up signal
（
LU
）
6
External stop command
（
EXT
）
7
Higher limit of frequency
（
FHL
）
8
Lower limit of frequency
（
FLL
）
9 Zero-speed running
10
Completion of simple PLC
operation
11
PLC cycle completion
indication
12
Preset counting value
arrival
13
Specified counting value
arrival
14 Inverter running state 15 Inverter is ready
（
RDY
）
16 Inverter fails 17 Extended function 1 of host
18 Reserved 19 Preset operation time out
The explanation of output signal is shown in Table 6-8.
0: Inverter running signal (RUN)
This signal will be given if the inverter is running.
1: Frequency arrival signal (FAR)
See F6.13.
2: Frequency detection threshold (FDT1)
See F6.14~F6.15.
3: Reserved
4: Reserved
5: Low voltage lock-up signal (LU)
The signal will be given when the DC bus voltage is lower than the low
voltage limit, and the LED displays “-LU-”.
6: External stopping command (EXT)
The terminal outputs the indicating signals if the inverter outputs tripping
signal caused by external fault (F.Ed).
7: Higher limit of frequency (FHL)
The signal is given if the preset frequency is higher than upper limit of
frequency and the operating frequency reaches the upper limit of frequency.
8: Lower limit of frequency (FLL)