HNC Electric HV610C Series, Руководство пользователя

Страница: 41 / 176

28
Section V. Parameter Function Table
Caution
：
The symbols in the function table are explained as follows
：
“
★
”
：
indicates that the parameter setup value cannot be modified when the inverter is in the
running status.
“●”
：
indicates that the parameter value is the actual detection record and cannot be modified.
“Change limit” indicates if the parameter is adjustable during operation.
When FP.00 is set to non-zero value, it means that the parameter protection password is
set and only when correct password is input can the user enter the parameter menu. To cancel
the password, FP.00 should be set to 0.
In the user set parameter mode , parameter menu is not protected by password protection.
F group, A group are of basic function parameters, U group is the monitor function group.
5.1 Monitor function group
：
U0.00-U0.61
U0 parameter group is used to monitor inverter running status .Customers can check through
panel for field commissioning as well as read parameter value through communication for position
machine monitoring. Among which, U0.00~U0.31 is defined for running or stop monitor parameter
by F7.03 , F7.04, F7.05.
For specific parameter function code
、
parameter name and minimum unit, please refer to the
table below.
Function code Designation
Unit
U0.00 Running frequency(Hz) 0.01Hz
Inverter current actual setting frequency
U0.01 Setting frequency(Hz) 0.01Hz
Inverter current actual output frequency
U0.02 DC bus voltage(V) 0.1V
Detection value of DC bus voltage
U0.03 The output voltage(V) 1V
Inverter actual output voltage
U0.04 Motor output current(A) 0.01A
Valid value of motor actual current
U0.05 The output power(kW) 0.1kW
The calculated value of actual output power of motor
U0.06 Output torque(%) 0.1%
The output torque of the motor