HNC Electric HV610C Series, Руководство пользователя

Страница: 39 / 176

Section IV. Keyboard Operation
26
4.3.5 Motor parameter automatic tuning
Vector control running mode
：
before running, user must accurately input motor nameplate
parameters. HV610C series inverter will be matching standard motor parameter according to
this nameplate. Vector control methods are very much dependent on motor parameters, to get
good control performance, accurate control motor parameters must be acquired.
Motor parameter auto tuning procedure is as follows
：
Firstly, select command source(F0.02) as operation panel command channel.Secondly,
input parameters below in accordance with motor actual parameter
：
Motor selection Parameter
Motor 1
F1.00
：
Motor type selection F1.01
：
Motor rated power
F1.02
：
Motor rated voltage F1.03
：
Motor rated current
F1.04
：
Motor rated frequency F1.05
：
Motor rated revolving speed
Motor 2
A2.00
：
Motor type selection A2.01
：
Motor rated power
A2.02
：
Motor rated voltage A2.03
：
Motor rated current
A2.04
：
Motor rated frequency A2.05
：
Motor rated revolving speed
Table 4-3.4
E.g
：
Asynchronous motor parameter tuning
If motor and the load can be totally separated, please select F1.37 (Motor 2as A2.37) to 2
(Asynchronous machine complete tuning), then press RUN key on keyboard panel, inverter will
automatically calculate the motor of the following parameters
：
Motor selection Parameter
Motor 1
F1.06
：
Asynchronous motor stator resistance
F1.07
：
Asynchronous motor rotor resistance
F1.08
：
Asynchronous motor leakage inductance
F1.09
：
Asynchronous motor mutual inductance
F1.10
：
Asynchronous motor no-load current
Motor 2
A2.06
：
Asynchronous motor stator resistance
A2.07
：
Asynchronous motor rotor resistance
A2.08
：
Asynchronous motor leakage inductance
A2.09
：
Asynchronous motor mutual inductance
F2.10
：
Asynchronous motor no-load current
Table4-3.5
If motor and the load can not be totally separated, please select F1.37(Motor 2\3\4 as
A2\A3\A4.37) to 1(Asynchronous machine static tuning), then press RUN key on keyboard panel.