HMS Networks Ixxat CANnector Log, Руководство пользователя

Страница: 10 / 38

Installation 8 (36)
5.2.2 Installing the Adhesive Feet
►
Stick the adhesive feet to the bottom of the device.
►
Place the CANnector on an even surface.
►
Make sure, that the venting slots are not covered and ensure adequate air circulation
(recommended mounting distance: 2 cm distance to venting slots).
5.3 Connecting the Device
Fig. 2 CANnector front connectors
Pin Allocation Power Connector
Pin Signal Description
1 G
Ground
2 P
Permanent power supply to provide power in standby mode (+6 to +36 V DC)
3 W Input to switch on the device (wake up)
For more information about the interfaces, the detailed pin allocations, available accessories,
and the LEDs see Installation Guide
CANnector .
► Make sure, that the software is installed (see Installing the Software, p. 7 ).
►
Connect the three pins of the power supply connector ( W , P , and G ) with the power supply.
A ready to use power cable is available as accessory from HMS Industrial Network.
►
Connect the CAN interfaces X1 to X4 to be used.
►
If required integrate a bus termination in the CAN connection.
► Connect the bus termination to the cable and/or to the connector.
► Use suitable cable assemblies for the CANnector Log, available from Ixxat.
► Plug in the USB memory storage device.
► Use only FAT32 or NTFS formatted USB memory storage devices.
► Switch on the power supply.
→ Default configuration with 250 Kbit/s starts automatically.
The logging only starts if the USB memory storage device is plugged in correctly.
CANnector Log User Manual
4.01.0091.21000 1.1 en-US