Hiwin HM-S, Руководство по сборке

Страница: 12 / 100

12
Description of the HM-S linear modules and HT-S linear tables
Assembly Instructions
Linear Axes HM-S and HT-S
HMS_HTS-01-0-EN-1905-MA
3.1.5 Order code for linear modules HM-S
Order code for linear modules HM-S (continuation)
1) Detailed information upon request or in the assembly instructions “HIWIN MAGIC Positioning Measuring Systems”
2) If no drive interface is selected, the order code ends at this position
3) All flange types can be found in Section 11.1 on Page 73 ff.
If no flange type is selected, the order code ends at this position
4) Suitable HIWIN motors can be found in the catalogue “Drives and Servo Motors”
5) Further reference switches on request
Clearance between
two carriages [mm]:
(000: One carriage only)
Carriage length:
S: Short
L: Long
Stroke length [mm]
Cover strip:
C: With steel cover strip
N: Without cover
HM 060 S 010 C 0755 L 000
HIWIN linear module
Size (profile width):
040: 40 mm
060: 60 mm
080: 80 mm
120: 120 mm
Drive type:
S: Ballscrew
Spindle lead [mm]:
005/010: HM040S
005/010/016: HM060S
005/010/020: HM080S
010/020/032: HM120S
Motor 4)
Flange type of motor 3)
A N N R HW03 FRLS2020506A
Axis limit switches 5) :
N: Without limit switches
A: 2 × NC, 100 mm cable, plug
C: 2 × NC, 4 m open cable end
D: 2 × NO, 5 m open cable end
Spindle supports:
N: Without spindle supports
1: One spindle support per side
(HM060/080/120)
2: Two spindle supports per side
(HM060/080/120)
3: Three spindle supports per side
(HM060/080/120)
Optional positioning measuring system 1) :
N: Without positioning measuring system
A: Positioning measuring system with
analogue signal
D: Positioning measuring system with
digital signal
Drive interface
2)
:
N: Without
S: Straight
L: Left
R: Right
A Top
B: Bottom
N S L R A B