Hiwin 25.12345, Руководство по сборке

Страница: 30 / 64

30
Assembly and connection
Assembly Instructions
Linear Tables HT-L
HTL-01-0-EN-1905-MA
Table 6.2 Minimum number of clamping profiles for securing the axis, and recommended spacing of mounting
points on long axes
X
Clean mounting surfaces at the carriage.
X
Clean the mounting surface of the load.
X
Position the load on the carriage of the linear table.
X
Tighten the mounting bolts crosswise.
X
If necessary, use centring sleeves.
X
Check the free movement of the load over the entire stroke.
X
Lock the bolts.
6.2 Mounting the imposed load
The spacings of the threaded holes for mounting the imposed load are identical for all drive options available to a size. They
can be found in the catalogue Linear Axes and Axis Systems HX”. Additional counterbores can take centring rings.
Size Thread size × depth Counterbore depth for centring sleeve
[mm]
Counterbore diameter for centring sleeve
[mm]
HT150 M6 × 14 1.5 Ø8 H7
HT200 M8 × 14 2.0 Ø12 H7
HT250 M10 × 20 2.0 Ø15 H7
Table 6.3 Threaded holes for securing the imposed load
9 9
The imposed load has now been installed.
Fig. 6.17 Securing the load with centring sleeves
Precision requirements for the imposed load’s mounting surface. 0.02
Size Min. number
of clamping
profiles
L
SY
[mm]
L
B
[mm]
Recommended
distance L
SX
[mm]
Thread
size
Screw
tightening
torque [Nm]
Clamping force
per clamping
profile [N]
F
A_perm.
1)
[N]
Art. no.
clamping
profiles
(4 pcs)
HT150 4 170 190 600 M6 10.1 8,600 1,600 20-001023
HT200 4 220 240 800 M8 18.5 17,000 3,000 20-000520
HT250 6 270 290 1,000 M8 18.5 17,000 5,000 20-000520
1) Permissible axial operating force in tension direction per pair of clamping profiles