Hivertec motionCAT HCPCI-MNT720M, Руководство пользователя

Страница: 94 / 168

83
3.11 B Module HM-A4199C
The B module is an analog, current input/output module with 4 analog input points and 1 analog output point.
3.11.1 Specifications
Category Item Specifications Remarks
Basic
specification
ASIC for Motionnet control G9002 by Nippon Pulse Motor
Input mode
Input count 4 points
Input current 4 to 20mA
Resolution 12 bits
Output mode
Output count 1 point
Output current 4 to 20mA
Resolution 12 bits
Function
specifications
Refresh cycle A/D value, D/A value, and status are refreshed every 0.4ms
D/A value output Manual output, preset output, automatic output by profile
Automatic output by D/A
profile
Automatic output of D/A values based on up to 15 points of

T (time) and voltage set in advance (preset).
A/D comparator
Upper and lower limits for comparison can be set for each channel. The result of the comparison is output as
status.
Safety feature
Communication cable
disconnection detection
Upon detection, the output current is maintained
Overcurrent protection
A PTC thermistor (poly switch) cuts the current when the current flowing through its receiving terminal
exceeds a certain amount.
Environment
requirements
Power supply DC +12V to DC +24V
Consumption current
Model no.
Consumption current
of the communication
board 24V terminal
Consumption current of the modul
e’s 24V power supply terminal
(Maximum load current when all outputs and inputs are at the maximum
(20mA))
HMG-B1 1.5A 2.3A Max.
HMG-B2 2.1A 3.7A Max.
Temperature requirement 0 to 50 degrees Celsius without dew condensation
Module dimensions
(Exc
luding the connector’s
projecting part)
Module: Depth 85mm × Height 105mm
Outer dimensions of the frame: Depth 110mm × Height 115mm × Width 14.2mm
Table 3.11-1 B module, HM-A4199C specifications
3.11.2 External Appearance
Figure 3.11-1 External appearance of B module, HM-A4199C
AD/DA connector
(J1)
Module's receiving terminal (P24-IN)
Module POW ON indicator
Internal logic circuit POW ON
indicator (Green)
(ON by in5V logic circuit POW
ON)