Hitecsa 1602.2, Инструкция по установке, эксплуатации и обслуживанию, Страница: 11 / 39

9
IOM_UMXCBA-UMXCA_801.1a4502.2_208027_200201_EN
UMXCBA/UMXCA
CONDENSER UNITS WITH
COMPRESSOR AND AXIAL FAN
TRANSPORT
INSPECTION AT RECEPTION

It is advisable to examine the equipment carefully upon reception.

Check that the equipment has not been damaged during transport and that it is complete with all
the parts specified in the order and/or the options stated in the order. If this is not the case please
contact the transport company immediately (within 48h).

Verify the correct voltage of the nameplate and make sure it is in accordance with local power
supply.

In case of any flaw or anomaly detected, please contact HITECSA.
RIGGING

Before moving the unit, make sure that all panels are fixed properly.

Raise and put the equipment down carefully.

Do not tilt the unit more than 15 degrees during transportation.

Always transport the unit in its original packaging to the place of installation.

All units come with a particular rigging diagram of that model similar to the one shown below. Be
sure to hoist the machine through the points indicated in the diagram.

Make sure that the unit is balanced, stable and without any deformations during the lifting
operations.
STORAGE
If the equipment is going to be stored before the installation, please follow the following instructions in
order to avoid damages, corrosion or deterioration:

Move the equipment carefully.

Do not place the unit in places exposed to ambient temperatures above 50ºC and preferably keep the
unit away from direct sunlight.

Avoid placing the unit with plastic wrapping protection under the sun as the pressure of the circuits could
reach values that could lead to the activation of the safety valves.
Moreover, with decreasing temperatures water condensation may occur inside the machine and the
plastic wrap.

Avoid placing other objects on top of the unit (unless this is done within the limits of the overlap planes
indicated on the packaging, etc. Follow these indications).

Avoid prolonged storage before installation, water penetration, dust and objects in general due to
invasion or biological, meteorological and/or human impacts.

Minimum storage temperature: -10ºC

Maximum relative humidity: 90%.