Hitec Luxembourg S.A. |
5, Rue de l’Église, L-1458 Luxembourg
www.hitec.lu | [email protected] | Tel.: (+352) 49 84 78 - 1 | Fax. (+352) 401303
File Name: HTCA_003-DADS-UserManual.docx
Document Type: End User Manual | Version date: 01/05/2010 | Last Printed: 15/02/2011
Page 36/81
Menu Configuration
Chamber
This menu allows to user to choose the chamber of the DADS machine. Different chambers
can be defined with the HITEC Config application.
This is useful in case different chambers are used on the same machine, or in case the
chamber is going to be replaced. All the maintenance data (Normalization and TLS) is linked
to this chamber. Like this it's not problem to change the chamber and keep the maintenance
data valid.
Chamber
reference
The identification of the chamber. These one and all below are defined in
the HITEC Config application in
ID
Shows the ID of the chamber.
Name
Display the name given to a chamber, normally its serial number.
TLS Mode
The TLS mode to which the chamber has been set. Target value, 70 %
or manual.
Target
Display the target carbon-black series used for the Normalization
Liquid
Displays the liquid used for the absorption test
Burette
resolution
The number of pulses the DADS terminal has to send to the burette to fill
out 50 ml of liquid. See Supported Burette Types paragraph.
Carbon-black
Target value
Displays the reference carbon-black and its target value for the TLS
measurement if the
Target value
or
70%
mode are selected.
TLS manual
value
Displays the torque value set on
Manual
mode.
Remark:
Per default a chamber with the name
Dummy
is installed. This is a chamber which
can be used for instance in case the user want to do some experimental
maintenance tests, which should not be recorded in the official maintenance files of a
specific chamber. Of course other test chambers can be defined too.
