2.
Select the type of transfer protocol to use.
3.
In
Primary Server
:
a. Click
Enable
to use the server or
Disable
not to use it.
b. Select the type of IP address to use for the server:
IPv4
or
IPv6
.
c. In
Client
Certificate
File Name
, click
Browse
to select a client
certificate
file.
4.
In
Secondary Server
:
a. Click
Enable
to use the server or
Disable
not to use it.
b. Select the type of IP address to use for the server:
IPv4
or
IPv6
.
c. In
Client
Certificate
File Name
, click
Browse
to select a client
certificate
file.
5.
In
Location
Identification
Name
, enter a name to use to identify the server.
6.
To set up an automatic attempt to reconnect to the server in case of communication
failure, in
Retry
, click
Enable
. Click
Disable
to not use this feature.
7.
If you enabled retry, in
Retry Interval
, enter the number of seconds that the
system will wait between retry attempts.
SNMP settings
Procedure
1.
Click the
SNMP
tab.
2.
In
SNMP Agent
, click
Enable
to use the agent or
Disable
not to use it.
SNMP settings
Chapter 6: Alert
notifications
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
180
Содержание Virtual Storage Platform F400
