Hitachi RAC-10SH3, Руководство по обслуживанию

Страница: 89 / 153

(1) Remove the lead wrie and ground wire from the electrical
parts box(CN8,CN10).
(2) Remove the left upper screw for the cleaning unit.
(3) Put your hand into the left side of the dust catcher,pull the
bottom slightly upwords,then remove it towards you,and
remove the left and middle and right lugs in sequence.
When installing the cleaning unit,ensure that the upper
lugs(x 3) are securely clicked into the holes.
(1) Press the hook lug of the electrical parts lid and
remove the lid.
(2) From the control P.W.B., remove the lead wires fixed
to the electrical parts box.
(3) Remove the screw that fixes the ground wire to the
electrical patrs box.
(4) Remove the screws that fixes the electrical parts box,
pull the bottom of the electrical parts towards and
remove it.
(1) Press the 「 STOP 」 button by remote controller,then
pull out the power plug from the electrical outlet.
(2) Remove the front panel.
(3) Remove the right stainless mesh filter.
(6) Facing the inside of the cleaning unit,remove the lugs
(X3) of the same side of the brush cover,and the brush
also will be taken down together.
At that time,you could use a minus-screwdriver or
something similar to remove the lugs.
(5) Ensure that 「 the brush (wiper) 」 is securely stop,and
then remove the cleaning unit.
(4) To insert the power plug , 「 the brush (wiper) of the
cleaning unit 」 will begin to move, waiting for 10~30
seconds,please pull out the power plug again.
(1) From the indicating P.W.B.,remove the lead wire.
(2) Remove the board upwards from the lug on the board
cover.
3. Cleaning unit
4. Control P.W.B. components
5. Indicating P.W.B.
– 87 –
Installation instructions
6. Brush (wiper) exchange method