Hitachi RAC-10SH3, Руководство по обслуживанию

Страница: 10 / 153

These are preset functions except for
(SA
VE).
Preset can be done if these buttons are pressed while the air conditioner is stopped, however
, the unit will not
function accordingly
.
FUNCTION SELECT
OR
Buttons Each time when you press, blinking changes in the following sequence (page 12, 21, 22, 23): ON/OFF Button Use this button to set or cancel the function selected by the function selector
.
FUNCTION SELECT
OR
(When the door is open)
MANUAL
CLEAN Button
Starts filter cleaning operation while the air conditioner operation is stopped. (Page 32)
F
AN SPEED Button
Press this button to select fan
speed.
VERTICAL
AIRFLOW
Button
Use this button to swing the vertical air deflector or to adjust the angle to your preference. (Page 24) HORIZONT
AL
AIRFLOW
Button Use this button to swing the horizontal air deflector or to adjust the angle to your preference. (Page 25) SET TIME Button Use this button to set and check the current time. (Page 1
1
)
TIMER Buttons RESET Button Press this button after the batteries are replaced and when the air conditioner does not function properly
. (Page 1
1
)
DEUTSCH FRANÇAIS ITALIANO SPANISH PORTUGUÊS
∂ÏÏËÓÈο РУССКИЙ
POWERFULL Button Press this button to start powerful operation. (Page 18) MANUAL/AUTO Button Press this button to switch between auto/manual dehumidifying and dry cool operation. (Page 17)
Four options are available: Auto, H
i, M
ed,L
ow,and Silent.
DYNAMIC AIR DEFLECTION Button Press this button to start dynamic air operation. (Page 20)
– 7 –
ENGLISH
10_14SH3_OM.indd 7 10_14SH3_OM.indd 7
2012-2-21 14:51:362012-2-21 14:51:36
•
2
•
T
ake out the anti-mold wasabi
cassette from the aluminium bag.
Do not remove or tear the aluminium sheet on the surface nor make a hole on it.
•
Remove the dust box housing
Dust Box Housing Dust Box Housing
INST
ALLING ANTI-MOLD W
ASABI CASSETTE
Open the front panel.
•
Do not hold the movable panel when opening and closing the front panel.
Front panel
Gripping part
Gripping part
Panel support
•
Hold and lift up the front panel.
•
Push up the panel support until it clicks to lock it. Lower the front panel and fix in position with the panel support.
Install the anti-mold wasabi cassette.
Aluminium bag
Slide the anti-mold wasabi cassette that has been taken out of the wrapper directly into the Dust Box Housing.
CAUTION
•
Do not put your face close to the package when you
open
it.
Y
our eyes or nose may be irritated by wasabi aroma.
•
Do NOT eat.
1
No daily maintenance is required. However
,
the effectiveness of anti-mold wasabi cassette will be lost after approximately 10 years have elapsed. Replace the anti-mold wasabi cassette in such event.
この中に「防カビわさびカセット」が入っています
●製品の取扱説明書を確認して確実に取り付けてください。
●開封時は顔を近づけないでください。
わさびの香り成分で、目や鼻に刺激を感じることがあります。
●「防カビわさびカセット」の表面のアルミシートを
はがしたり、破ったり、穴をあけたりしないでください。
「防カビわさびカセット」の効果がなくなります。
●食べられません。
注
意
CAUTION
•
Do not open the front panel during operation
.
It may interrupt the movable panel to work properly
.
Be sure to stop
the operation first before opening
the front panel.
Anti-mold wasabi cassette
– 8 –
10_14SH3_OM.indd 8 10_14SH3_OM.indd 8
2012-2-21 14:51:362012-2-21 14:51:36
Handle