Hitachi L300P Series, Инструкция по эксплуатации

Страница: 58 / 272

Step-by-Step Basic Installation
In
v
e
rt
er Moun
ting
and Install
a
tion
2–16
Terminal
Dimensions and
Torque Specs
The following tables list the screw size of terminal and recommended torque for tightening for
each of the L300P inverter models (400V models are on the next page).
CAUTION:
Fasten the screws with the specified fastening torque in the table below. Check for
any loosening of screws. Otherwise, there is the danger of fire.
Note 1: The recommended ring lug connector listing consists of wire size – screw size
format. The wire sizes are in AWG or mm
2
format. For AWG wire sizes, bolt sizes
for the ring lug centers are: #10, #12, 1/4”, 5/16”, and 1/2”. For metric wire sizes, bolt
sizes for the ring lug centers are: 6 = 6M, 8 = 8M, 10 = 10M
TIP: AWG = American Wire Gauge. Smaller numbers represent increasing wire thickness.
kcmil = 1,000 circular mils, a measure of wire cross-sectional area
mm
2
= square millimeters, a measure of wire cross-sectional area
Input
Voltage
Motor
Output
200V
Inverter
Models,
L300P
Screw size
of terminal
Ring Lug Connector *1 Torque
HP kW (AWG–bolt)
(mm
2
–bolt)
ft-lbs N-m
200V
2 1.5 –015LFU2 M4 14–#10 2–4 1.1 1.5
3 2.2 –022LFU2 M4 14–#10 2–4 1.1 1.5
5 3.7 –037LFU2 M4 10–#10 3.5–4 1.1 1.5
7.5 5.5 –055LFU2 M5 8–#12 5.5–5 1.8 2.5
10 7.5 –075LFU2 M5 6–#12 8–5 1.8 2.5
15 11 -110LFU2 M6 4–1/4 14–6 3.6 4.9
20 15 -150LFU2 M6 2–1/4 22–6 3.6 4.9
25 18.5 -185LFU2 M6 1 30–6 3.6 4.9
30 22 -220LFU2 M8 1–5/16 38–8 6.5 8.8
40 30 -300LFU2 M8 2–5/16 60–8 6.5 8.8
50 37 -370LFU2 M8 2–5/16 100–8 6.5 8.8
60 45 -450LFU2 M10 1–1/2 100–10 10.1 13.7
75 55 -550LFU2 M10 2/0–1/2 150–10 10.1 13.7
100 75 -750LFU2 M10 3/0–1/2 150–10 10.1 13.7