Hitachi IJ RX2, Руководство по обслуживанию

Страница: 210 / 252

6-31
6.3.9 Target Spacing Too Close
6.3.10 Print Data Changeover In Progress S/M/V
Target Spacing
Too Close
Is the sensor chattering?
Ensure that the sensor does
not chatter.
Yes
No
Are there more than four
workpieces (print targets)
between the sensor and
print head?
No
Replace the EZJ126 board.
Decrease the clearance
between the sensor and
print head and reduce the
number of workpieces
between the sensor and
print head to four or less.
。
Yes
The print target detection signal entered while the printer was not
ready. See that the print target detection signal enters after a while.
SUPPLEMENT
Print Data Changeover
In Progress
Resume the
operation.
There is a way to set the item “Print data changeover” on User
environment setup menu to “Disable”.
Refer to the Instruction Manual, ”6.1 Set the user environment;
Print Data Changeover In Progress error”.