Hitachi GR4000-160E1, Быстрый старт

Страница: 50 / 85

GS4000 Quick Start Guide, Revision 3
32
QSGGS4KX10-00 5794092-2X
4.1 Settings at the Time of Initial System Introduction
At the time of initial introduction of system, a default VLAN (VLAN1) is set for GS4000 so that it can work as a
layer2 switch using only one VLAN. When you use GS4000 only as a layer2 switch, you can start communications
through GS4000 only by connecting interface cables to it without setting configuration information.
NOTE It is recommended that you set a time, user ID and a password of administrator referring to the
section “4.2 Startup of GS4000” even when you use GS4000 only as a layer2 switch.
4.2 Startup of GS4000
The following “login” prompt is shown after starting up GS4000.
BSDI BSD/OS 3.1
login:
4.3 Setting a Time, User ID and Password of Administrator
This section explains how to log into GS4000 and set a time or a password of administrator as well as how to create
a new user ID.
(1) Log into GS4000.
Log into GS4000 by inputting a user ID. The “operator” is a default user ID set at the time of initial system introduction. （This
default user ID does not have a login password set for it.）
login:
operator
…
Input
“
operator
”
as a user ID.
All Rights Reserved,Copyright(C)2003,2004,Hitachi,Ltd.
*** Welcome to the system ***
>
4.2 Startup of GS4000
4.3 Setting a Time, User ID and Password of Administrator
4.1 Settings at the Time of Initial System Introduction