English
18
BATTERY REMOVAL/INSTALLATION
1. Battery
removal
Hold the handle tightly and push the battery
latch to remove the battery (See
Fig.1
and
2
).
CAUTION
Never short-circuit the battery.
2. Battery
installation
Insert the battery while observing its
polarities (See
Fig. 2
).
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate
faces toward the ventilation slots of the
charger and press in the battery until it
comes into contact with the bottom plate.
(See
Figs. 1
and
3
)
2. Connect the charger power cord to the
receptacle.
Connecting the power cord will turn on the
charger (the pilot lamp lights).
CAUTION
If the pilot lamp does not light, pull out the power cord from the receptacle and
check the battery mounting condition.
About 1 hour is required to fully charge the battery at a temperature of about 20°C. The pilot
lamp goes o
ff
to indicate that the battery is fully charged.
CAUTION
If the battery is heated due to direct sunlight, etc., just after operation, the charger
pilot lamp may not light. At that time cool the battery
fi
rst, then start charging.
Rechargeable
battery
Latch
Fig. 1
Handle
Insert
Pull out
Rechargeable
battery
Latch
Push
Fig. 2
Insert
Rechargeable
battery
Pilot lamp
Hole for connecting the
rechargeable battery
Fig. 3
000Book̲DN10DSA̲ChS.indb 18
000Book̲DN10DSA̲ChS.indb 18
2017/04/04 10:57:36
2017/04/04 10:57:36