-18-
Fig. 14
Fig. 15
(c) Mount Pushing Button (A)
[34]
to housing (A) of Housing (A).(B) Set
[31]
. At this time, check that the
protrusion of the forward/reverse changeover lever of the DC-Speed Control Switch
[35]
fits in the U-
shaped groove of Pushing Button (A)
[34]
properly.
(d) Align the protrusion and the concave portion of Controller (B)
[39]
with the concave portion and the
protrusion of Housing (A).(B) Set
[31]
respectively (Fig. 14). Connect the internal wires that connect
Controller (B)
[39]
with the DC-Speed Control Switch
[35]
in the order of red, blue and white (Fig. 15).
(e) Put housing (A) and housing (B) of Housing (A).(B) Set
[31]
(B) together and tighten the seven Tapping
Screws (W/Flange) D3 x 16 (Black)
[36]
. (Be careful not to pinch the internal wires.)
(f) When the reassembly procedure is completed up to step (e), ensure that every indication on the Clutch
Dial
[6]
from number "1" to the drill mark " " can be aligned with the triangle mark on Housing
(A).(B) Set
[31]
respectively by turning the Clutch Dial
[6]
. If any indication on the Clutch Dial
[6]
cannot
be aligned with the triangle mark on Housing (A).(B) Set
[31]
, correctly remount the Nut
[8]
according to
step (2) (b) as the Nut
[8]
is not mounted properly. Turn the Clutch Dial
[6]
to check for clicking. If no
click is heard, the Click Spring
[7]
is not mounted properly. Correctly remount the Click Spring
[7]
according to step (2) (c).
Housing (A).(B) Set
[31]
Controller (B)
[39]
Protrusion
Protrusion
Concave portion
Concave portion
Internal wire
