Hitachi CP-X445, Руководство пользователя

Страница: 60 / 84

3
ENGLISH
Adjusting the projector's elevator / About the filter cover for bottom - up use
About the filter cover for bottom - up use
WARNING
►For the projector installed bottom-up, use the accessory filter
cover for bottom-up use. And in the case of a ceiling installation or the like,
contact your dealer before installation.
►Do not replace the filter cover during use or immediately after use. While the
projector connects with a power supply, or the projector is in a high temperature
state, handling could cause an electric shock, a fire, a burn and/or malfunction
to the projector.Before handling, make sure the power switch is off and the
power cord is not plugged in, then wait at least 45 minutes.
1.
After making sure that the projector is cool adequately,
slowly turn the projector so that the lens-side is facing
up. Please be careful for a projector not to fall. While the
projector is placed lens-side up, hold the projector.
2.
Unhooking the filter cover’s claws, pull the filter cover in
the direction of the arrow to remove it.
3.
Replace the filter cover for bottom-up use and snap it
back into place.
4.
Slowly turn the projector so that the top is facing up.
Adjusting the projector's elevator
WARNING
►Do not adjust the projector’s elevator during use or
immediately after use. Handling while the projector is in a high temperature
could cause a burn and/or malfunction to the projector.
CAUTION ►If you press the elevator button without holding the projector,
the projector might crash down, overturn, smash your fingers and possibly result
in malfunction. To prevent damaging the projector and injuring yourself, always
hold the projector whenever using the elevator buttons to adjust the elevator feet.
►Except for inclining by the elevator feet adjustment, place the projector
horizontally.
1.
After making sure that the projector is cool adequately,
press and hold in the elevator buttons while holding the
projector. The elevator buttons and the elevator feet are on
the both sides.
2.
Raise or lower the projector to the desired height and the
release the elevator buttons.
When you release the elevator buttons, the elevator feet
will lock into position.
3.
As necessary, you can also finely adjust the height of the projector by twisting
the elevator feet by hand.
Elevator
feet
Elevator
button