Hitachi 53SBX01B, Руководство по эксплуатации

Страница: 45 / 105

USING THE REMOTE TO CONTROL SATELLITE RECEIVER FUNCTIONS
45
NOTES:
1. If your cable box cannot be operated after performing the above procedures, your cable box
code has not been precoded into the remote.
2. In the unlikely event that your cable box cannot be operated after performing the above
procedures, please consult your cable box operating guide.
3. The remote control will remember the codes you have programmed until the batteries are
removed from the remote control. After replacing the batteries repeat the entire programming
procedure stated above.
4. The LAST CH button will act as your cable box ENTER button if required.
5. The SLEEP button will act as your audio components '100' button if required.
(1) CABLE (CBL) Button
This button allows the remote to control your cable box by setting it to CABLE mode.
(2) PRECODED CABLE Box buttons
These buttons transmit the chosen precoded cable codes.
(3) EXCLUSIVE TV buttons
These buttons are for operating the TV.
MY CABLE BOX CODE IS:___________________
NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively
for the Cable Box.
USING THE REMOTE TO CONTROL SATELLITE RECEIVER FUNCTIONS
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of satellite systems. You must first program
the remote to match the remote system of your satellite receiver. (refer to page 34.)
1. Turn ON your satellite receiver.
2. Aim the remote control at the front of your satellite receiver.
3. Press and release the SATELLITE (SAT) button on the remote to switch to satellite pre-
coded mode.
4. Hold down the SAT button on the remote and enter the two digit preset code that matches
your satellite receiver as shown on page 34. The indicator light will flash 3 times if the code
was accepted.
5. Aim the remote at the Satellite receiver and press the POWER button. The remote will turn
off your Satellite receiver when the correct two digit preset code is entered. When this occurs,