Hitachi 35TX10B, Руководство по эксплуатации, Страница: 49 / 94

USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
49
USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
Operating the pre-Coded function for your VCR
This Genius Remote is designed to operate different types of VCRs. You must first
program the Genius Remote to match the remote system in your VCR. (Refer to Table 1
on page 36 or Table 3 on page 37.)
1. Set the MULTI-PAGE select switch to "VCR".
2. Set the USE/LEARN mode select switch on the rear side of the Genius Remote to
"USE." (For CLU-850GR only)
3. Turn ON your VCR.
4. Aim the Genius Remote control at the front of your VCR.
5. While holding down the SELECT button, press the button that matches your VCR as
shown on page 36 or page 37. Continue to hold down both buttons. The channels of the
VCR will begin changing when the correct button is pressed. When this occurs, the
Genius Remote Control is programmed for your VCR. If the VCR channels do not
change after 5 seconds, try a different Genius Remote button.
6. Release both buttons when the VCR starts to change channels. The Genius Remote
will now control your VCR.
Click here to see the CLU-850GR in the VCR position.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that
your VCR's codes have not been precoded into the GENIUS REMOTE. Please store your
VCR codes in memory by using the USER mode. (Refer to page 38.)
2. The GENIUS REMOTE CONTROL will remember the codes you have programmed in
until the batteries are removed from the GENIUS REMOTE CONTROL. After replacing the
batteries repeat the entire programming procedure stated above.
3. If you have a play back only VCR (no CH UP/DOWN function), please follow operating
step 5 described above and then check a VCR function until you find the button that will
allow the precoded VCR buttons to operate your VCR.
PRECODED VCR BUTTONS
These buttons always transmit the chosen precoded VCR codes.
SELECT BUTTON
This is for setting up the Genius Remote to transmit the VCR's remote codes.