Hitachi 3100, Руководство по администрированию сети

Страница: 42 / 89

Procedure
1. Navigate to Network Configuration > Link Aggregation to display
the Link Aggregation page.
2. Select the check box next to the aggregation name to delete.
3. Click delete to remove the aggregation. When deleting an aggregation,
there is no confirmation required. The aggregation is deleted
immediately.
Configuring LACP
To enable LACP for an aggregation using the CLI instead of the SMU, use the
aggedit
command as shown in the example below:
aggedit lacp ag1
where
ag1
is the required aggregation interface.
File serving interfaces which are connected to a LACP enabled switch must be
manually added to an LACP aggregation as shown in the example below:
aggedit add ag1 tg1,tg2
where ag1 is the aggregation and
tg1
and
tg2
are the file serving interfaces.
To view the status of LACP for an aggregation, use the
lacp
command.
Configuring LACP timeouts
To set a short LACP timeout, use the
lacp-set-timeout-short
command as
shown in the example below:
lacp-set-timeout-short ag1
where
ag1
is the required aggregation interface.
To set a long LACP timeout, use the
lacp-set-timeout-long
command as
shown in the example below:
lacp-set-timeout-long ag2
where
ag2
is the required aggregation interface.
Additional commands
• agg - this command lists any existing aggregations
• lacp-set-timeout-default - this command selects the default LACP
timeout (short timeout)
• lacp-show - this command displays the LACP configuration
42 Configuring link aggregation
Hitachi NAS Platform Network Administration Guide