Hitachi 3080 G2, Справочник по аппаратуре

Страница: 62 / 129

Removing and replacing the front bezel
To access some server components, or field replaceable units (FRUs), you
must first remove the front bezel. Replace the bezel after the part
replacement is complete.
Bezel removal
The server bezel is held onto the server chassis through a friction fit onto
four retention posts, which are mounted to the chassis along the left and
right edges of the chassis. There are no screws or other fasteners.
There are four (4) retention screws that hold the bezel retention posts onto
the chassis.
Figure 6-1 Server front bezel with grasping areas
Procedure
1. To remove the bezel, grasp the front of the bezel by the grasping areas.
2. Gently pull the bezel straight out away from the server.
Bezel replacement
Procedure
1. Place the bezel on the server, making sure that the bezel fits inside the
outer edges of the chassis and that the retention posts and status LEDs
are aligned.
2. Using the solid portions of bezel (near the edges), press the bezel
straight into the server until it is firmly in place against the server
chassis.
Replacing a fan
Replace a fan assembly, which is one of the server's hot-swappable
components.
62 Replacing server components
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide