Hitachi 3080 G1, Справочник по аппаратуре

Страница: 90 / 138

described in Step1: Performing an Internal Drive Health Check on
page 83 . If the command response displays issues, resolve them if
possible, or contact technical support for assistance.
Step 3: Backing up the server configuration
Backing up the server’s configuration for an internal or external SMU saves
the server’s configuration, including the SI configuration. When backing up a
server with an internal SMU, the configuration backup also includes a ZIP file
of the SMU configuration.
Procedure
1. Connect your laptop to the management Ethernet switch using an
Ethernet cable.
2. Log in to Web Manager.
3. Navigate to Home > Server Settings > Configuration Backup &
Restore .
4. Click backup to save the configuration file to your laptop.
5. Verify that the backup file is complete and make sure the file size is not 0
bytes
Step 4: Locating the server
Before shutting down the server/node to replace disks, you must physically
locate the server.
Procedure
1. Run the
led-identify-node X
command.
where X is the number of cluster node (the pnode-id) to identify.
The result of this command is that the server’s fault and power LEDs
(located on the left side of the server’s rear panel) flash simultaneously.
90 Hard disk replacement
Hitachi NAS Platform 3080 and 3090 G1 Hardware Reference