Hitachi 3080 G1, Справочник по аппаратуре

Страница: 123 / 138

7. Label the cables connected to each of the ports on the node, and
disconnect the cables once they have been labelled. Ensure that you use
dust covers where required.
8. Remove the old node from the rack.
9. Place the old node into the packaging that the new node was shipped in
and mark it as a bad part.
Installing the new node
You are now ready to install the new node.
Procedure
1. Physically rack the new node into the place of the old node.
2. Connect the cables to the new node, according your labelling.
3. Power up the new node and ensure that BALI loads again.
4. If the customer is using SAN attached, and/or host group security,
update this to reflect the changes that are being made to the WWN, as
you documented previously in Preparing the node, step 5.
5. Add the new node as a managed server on the SMU.
6. From the drop down in the SMU, select the existing Cluster.
7. Go into Home > Sever Settings > Cluster Configuration and click on
AddCluster node .
8. Complete the add cluster node wizard , selecting the new node which
will appear in the selection box, and enter the supervisor password
where prompted (the default is
supervisor
). Upon completion of the
wizard, the new node will reboot and join the cluster.
Finalizing and verifying the server configuration
On the new server:
Procedure
1. Navigate to Home > Status & Monitoring > System Monitor to verify
the server status:
Server replacement procedures 123
Hitachi NAS Platform 3080 and 3090 G1 Hardware Reference