Connecting to External Devices
Remote & Accessories
Connect remote or other accessories, such as keyboard, mouse, to interact with your Smart TV with ease.
Connect Remote Control
Connect a Bluetooth remote control
Pair the Bluetooth remote with the TV.
1.
To pair the Bluetooth remote to the TV after you power the TV on, select
>
Settings
>
Network
>
Bluetooth
to
On
.
2.
Keep the remote within 3 metres of the TV. Press any button (except power and mic button) to pair the
remote with the TV.
Note:
• In special cases, press and hold
button to pair.
• This function may not be applicable in some models/countries/regions.
• If an error occurred while trying to pair the remote, it could have been caused by interference. Try to
remove what is causing the interference and try pairing again.
• If an error occurred with the remote while using sufficiently charged batteries, you can take out the
batteries for 1~2 seconds then insert them back again. Now the remote will work normally.
• The remote cannot be paired to the TV while the TV is in standby mode.
Use HDMI-CEC
Use the TV remote to control external devices that are connected to the TV by a HDMI cable. The external
devices need to support HDMI & CEC function.
>
Settings
>
System
>
HDMI-CEC
Connect an external device through HDMI-CEC function
>
Settings
>
System
>
HDMI-CEC
>
HDMI-CEC
Allow HDMI devices to control each other.
1.
Set
HDMI-CEC
to
On
.
2.
Connect a HDMI & CEC compatible device to the TV.
3.
Turn on the connected external device. The device will be connected to the TV automatically. After
connection is completed, you can access the menu of the connected device on your TV screen using your
TV remote and control the device.
4.
When CEC control is enabled and HDMI & CEC compatible external devices are turned off, the TV will
enter the standby mode. The function needs to be supported by the external device.
Enable device auto power off
>
Settings
>
System
>
HDMI-CEC
>
Device Auto Power Off
Set to
On
to turn off HDMI & CEC compatible external devices when the TV is turned off.
Enable device auto power on
>
Settings
>
System
>
HDMI-CEC
>
Device Auto Power On
21