Hirschmann BAT 11b, Руководство по управлению

Страница: 30 / 128

After the Successful Commissioning
30
BAT 11b
Release 1.0 03/04
After the Successful Commissioning
After connecting the BAT 11b to the mains power supply and
setting up a connection to your Ethernet, it is ready for use. A
BAT 11b Wireless Ethernet can be operated either in access
point mode (BAT 11b-AP) or in access client mode (BAT 11b-AC).
In the state as delivered, it works as access point and can be
operated as access client by means of a firmware upload. Also
refer to Section
How to Upgrade the Firmware on Page 2–51 .
Prerequisite:
If you are using a PC with an radio client, you can immediately
access your Ethernet via the BAT 11b, since the communica-
tions parameters match in this configuration.
Note:
To adapt the radio client to already existing configurations of
wireless networks, specific settings of the communications
parameters are required.
Prerequisite:
To be able to configure these settings, you have to start the
configuration via a browser. To do this, an IP address has to be
assigned to the BAT 11b via the Hirschmann BAT Discovery
(see Section
The Basic Configuration ).