background image

HIRED-HAND, INC

 1733 County Road 68 

 Bremen, AL 35033 

 PHONE 256-287-1000 

 FAX 256-287-2000 

Manual Part No. 4801-5125 Rev 12-02            Page 1 of 4  

M E G A   F L O W   F A N  

(See Reverse Side for Framing & Shutter Installation Instructions)

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

1.  Disconnect power source before installing or 

servicing fan.  Failure to disconnect power 
source can result in property damage, 
serious injury, or death. 

2.  When connected to an automatic controller, 

FAN MAY START AT ANY TIME. 

3.  IMPORTANT!  Before Operating Fan, Inspect 

Fan For any Object That May Obstruct Blade 
Rotation. 

WARNING! 

SLANTWALL 

(ASSEMBLED) 

 

 

BEFORE INSTALLING 

1.  Inspect fan for damage in transit.  Check for 

loose, missing, or damaged parts. 

2.  If there are any missing parts or if there is 

any shipping damage, do not attempt to 
operate fan.  Contact your Distributor. 

1. 

Read WARNING statements before proceeding.

 

2. 

Blades, motor, and wire guards should be cleaned 
periodically to decrease vibration and ensure 
maximum fan life.  Remove dirt with a dry brush or 
compressed air.  DO NOT SPRAY MOTOR WITH 
WATER OR CLEANING FLUIDS. 

3. 

Fan performance may be greatly reduced by 
damaged or dirty shutter.  Clean and inspect shutter 
periodically to ensure maximum fan performance.

 

MAINTENANCE 

When this fan is used in a life support ventilation 

system where failure could result in loss or injury, 

the user should provide adequate backup 

ventilation, or accept the risk of such loss or injury.

IMPORTANT! 

INSTALLATION 

1.  Fan should be securely mounted to wall.  

Refer to mounting instructions on sheet 3 
of this manual. 

2.  Fan is provided with wire guard for your 

protection. 

National safety codes require that guards 
be installed if within 7 feet (2.1 m) of floor 
or within reach of personnel or livestock. 

3.  If thermostat is used, connect fan power 

cord to controller. 

WARRANTY 

Your Mega-Flow fan has been manufactured with the finest 
materials and components available and is backed by a one year 
warranty against electrical and mechanical defects in material and 
workmanship.  If this fan fails to operate during this period, return it 
prepaid to place of purchase for repair or replacement without 
charge at the manufacturer's option. 
This warranty gives you specific legal rights and you may have other 
rights that vary from state to state. 

Содержание Mega Flow Slantwall

Страница 1: ...R CLEANING FLUIDS 3 Fan performance may be greatly reduced by damaged or dirty shutter Clean and inspect shutter periodically to ensure maximum fan performance MAINTENANCE When this fan is used in a life support ventilation system where failure could result in loss or injury the user should provide adequate backup ventilation or accept the risk of such loss or injury IMPORTANT INSTALLATION 1 Fan s...

Страница 2: ...6 49 75 126 4 cm 48 63 0 160 0 cm 52 67 0 170 2 cm FRAMING DIAGRAM Clear Opening Width W Height H INTAKE SHUTTER SIDE EXHAUST ORIFICE SIDE See Framing Dimensions Below Rough Opening Rough Opening Fan Size Fan Model Width Height 36 Mega Flow Slantwall 42 75 108 6 cm 43 75 111 1 cm 48 Mega Flow Econo Flow 54 75 139 cm 54 13 137 5 cm 48 Mega Flow Slantwall 54 75 139 cm 55 75 141 6 cm 52 Mega Flow Sla...

Страница 3: ...mly attach fan to wall Latch See next page for instructions on latching shutter 1 Carefully lift fan into position 2 Securely attach fan to wall with screws not provided NOTE Route power cord through access port in top of cabinet as shown M O U N T I N G I N S T R U C T I O N S CAUTION Fan Is Heavy Do Not Attempt To Lift Fan Without Sufficient Workers And Equipment ...

Страница 4: ...anually open vanes of shutter to access latch Fasten latch located inside fan housing into slot in flange of shutter Firmly lock down latch Repeat procedure to latch opposite side of shutter S H U T T E R I N S T A L L A T I O N Shutter Fits Onto Intake Side Of Fan 1 Lift shutter 2 Check that shutter is flush against housing at all points 3 Manually open vanes of shutter to gain access to latches ...

Отзывы: