Hioki SW1001, Инструкция по эксплуатации, Страница: 35 / 164

31
Channel Switching Operation
3.4 Channel Switching Operation
When the channel is selected (closed), channel switching is performed according to the following
flow.
Channel switching
Enabled channel Previous channel Selected channel
Relay operation Close Open Close
Operation
standby time
Settling time
Channel
delay
EXT. I/O CLOSE ON OFF ON
Set pulse
width
If the next channel is closed before the CLOSE signal pulse reaches the set pulse width, CLOSE
signal pulse will automatically turn off.
After the previous channel relay is opened, the selected channel relay is closed (break before
make).
Channel switching cannot be overlapped (make before break).
In channel switching within the same slot, the bus relay is not opened and only the channel relay is
switched.
If the channel for a different slot is selected, the bus relay and channel relay of the previous slot are
opened and the bus relay and channel relay of the selected slot are closed.
After the channel relay is closed and then the settling time that is automatically set and the channel
delay time that is specified by the customer elapse, channel switching operation is complete and
the CLOSE output signal of EXT. I/O is turned on (pulse output at the set pulse width).
3
Channel Switching