Hioki SW1001, Инструкция по эксплуатации

Страница: 133 / 164

129
11
Multiplexer Module
Thoroughly read "Before installing the module" (p. 5) beforehand.
11.1 SW9001 Multiplexer Module (2-wire/4-wire)
Features
The SW9001 is a multiplexer module that can be attached to the SW1001 or SW1002 Switch
Mainframe.
• 2-wire 22-channel or 4-wire 11-channel multiplexer
• The module reduces electromagnetic induction (eddy current) in AC impedance measurement
and minimizes the influence on measured values by reducing magnetic flux leakage due to
measurement current and separating the source wire from the sense wire.
• It can be connected up to 2 instruments by switching the analog bus.
Specifications
General Specifications
Operating
environment
Indoor, pollution degree 2, altitude up to 2000 m (6562 ft.)
Operating
temperature and
humidity
Temperature 0°C to 40°C (32°F to 104°F)
Humidity 80% RH or less (no condensation)
Storage temperature
and humidity
Temperature −10°C to 50°C (14°F to 122°F)
Humidity Less than 40°C (104°F), 80% RH or less (no condensation)
40°C (104°F) or higher and less than 45°C (113°F), 60% RH or less (no
condensation)
45°C to 50°C (113°F to 122°F), 50% RH or less (no condensation)
Standards
Safety EN61010
EMC EN61326 Class A
Dimensions Approx. 25.5W × 110H × 257D mm (1.00"W × 4.33"H × 10.12"D) (excluding the projection)
Mass Approx. 210 g (7.4 oz.)
Product warranty
period
3 years
Relays, fuses, and connector: Not covered by the warranty
Accessory Instruction Manual
11 Multiplexer Module
11
Multiplexer Module