Hioki SW1001, Инструкция по эксплуатации

Страница: 103 / 164

99
Message Reference
(5) Scan Function
Register and query scan list
Syntax Command
[:ROUTe]:SCAN<(@
Channel list
)>
Query
[:ROUTe]:SCAN?
Response <(@Channel list)>
Specify the channel list in the following formats.
<CH>,<CH>, ..., <CH> Specify the channels to be measured individually.
<CHm>:<CHn> Specify from CHm to CHn consecutively.
Description Registers the scan function scan list (channel list to be switched). Specify the channel
using the combined number of the slot number and channel number inside the module
<Slot No.> × 100 + channel number inside the module).
Up to 1000 channels can be registered for the scan list.
(@) can be omitted.
Example
:SCAN (@101,102,103,201,202)
Scanning is performed in order of 101, 102, 103, 201, and then 202.
:SCAN (@101:312)
Scanning is performed from 101 to 312.
:SCAN 1001:1222
Scanning is performed from 1001 to 1222.
:SCAN?
(@101,102,103,201,202)
Scanning is set to be performed in order of 101, 102, 103, 201, and then 202.
Note An execution error occurs during scan operation (command).
Adding to the scan list
Syntax
Command
[:ROUTe]:SCAN:ADD <(@
Channel list
)>
<(@Channel list)>
Specify the channel list in the following formats.
<CH>,<CH>,...,<CH>
Specify the channels to be measured individually.
<CHm>:<CHn> Specify from CHm to CHn consecutively.
Description Adds a list of channels to the end of the present scan list.
A total of up to 1000 channels may be registered. Attempting to add 200 channels if there
are presently 900 channels registered will result in an error, leaving the original scan list
of 900 channels (none of the 200 channels will be added). You can check the number of
channels that can be added by using the
:SCAN:SIZE?
query.
Example
:SCAN 101,102
:SCAN:ADD 201,202
Scan list is 101, 102, 201, and 202.
Note An execution error occurs during scan operation (command).
Delete scan list
Syntax
Command
[:ROUTe]:SCAN:REMove
Description Deletes the scan list.
Example
:SCAN:REM
The scan list is deleted.
Note An execution error occurs during scan operation (command).
8
Communication Function