Hioki SS7081-50, Инструкция по эксплуатации

Страница: 43 / 71

40
Standard commands
(1)
System data command
Query the instrument version
Syntax
Query *
IDN?
Response <Manufacturer name>,<Model name>,<Serial No.>,<Software version>
Example
*
IDN?
HIOKI,SS7081-50,123456789,V2.00
Returns the model version.
(2)
Internal operation commands
Initialize the instrument
Syntax
Command *
RST
Description
Command Initializes the instrument.
[Common to all channels]
Setting items Default setting
Output terminals OFF
Output terminal when the output terminal is set to ON. NORMAL
Output terminal when the output terminal is set to OFF. ZERO
Output expansion terminal (CHAIN terminal) ON
Output voltage 0.0000 V
Memory outputs OFF
Output time 0.001 s
Output voltage 0.0000 V
Measurement range 1 A
Smoothing OFF
Logging measurement OFF
Overcurrent error threshold value 1 A
Output voltage error threshold value 2.0 mV
Threshold value of temperature error inside the case
(control board)
50 ºC
Threshold value of temperature error inside the case
(output board)
70 ºC
Interval for which error detection is disabled after
switching to the 100 μ A range
1.000 s
Note
• Implementing this command while data is being transferred using the logging
acquisition query will delete the saved data.
• Implementing this command during overcurrent detection will cancel the output stop
status.
Implement :VOLT , and set the desired output voltage.
Initiate a self-test and queries the result
Syntax
Query *
TST?
Response <PASS/FAIL>
Description
Performs the instrument self-test and returns the result.
Returns PASS when no error occurs and FAIL when an error occurs.
An execution error occurs during logging. Performing
＊
TST? after logging completes will
cause all saved data to be cleared.
Example
*
TST?
FAIL
An error occurs. The correct measurement may not be performed. Stop using the
instrument and send it for repair.
HIOKI SS7081C961-00