Hioki SM7860 Series, Инструкция по эксплуатации

Страница: 17 / 64

13
Screen Configuration
1.3 Screen Configuration
The display (LCD) consists of two display pages (Screen P1, Screen P2).
• Screen P1 is displayed when the device is turned on.
• The display pages can be scrolled using the scroll keys ( [PAGE UP▲] , [PAGE DOWN▼] ) to the right of
the screen.
• You can select a display page directly by sending a “
PAG
” command from the GP-IB or RS-232C
interface. Refer to “3.6 Message List” (p. 34)
Screen P1: Displays output voltage settings
V A ( + ) I R : 1 0 0 0 . 0
V B ( + ) I R : 2 5 0 . 0
T E R M I N A L :
O U T 1 : 1 1 1 0 0 0 0 0
O U T 2 : 1 1 1 0 0 0 0 0
O U T 3 : 1 1 1 0 0 0 0 0
O U T 4 : 1 1 1 0 0 0 0 0
V M A : 1 0 0 0 . 0
V M B : 2 5 0 . 0
C L M 1 : 1 0 m A
C L M 2 : 1 0 m A
C L M 3 : 1 0 m A
C L M 4 : 1 0 m A
O K
O K
TEMP
TEMP
L
1
3 4 5 6
2 7
P1
1
Output voltage setting VA : Displays the power supply A circuit voltage setting.
VB
: Displays the power supply B circuit voltage setting.
( Display example: VA (+) IR: 1000.0
Indicates that the power source’s A circuit is set to 1000.0 V.)
2
Temperature error display When a temperature error is detected,
TEMP
blinks.
3
Key lock display When the keys are locked,
L
is displayed.
4
Terminal output setting
state
Displays rows 1 through 8 of
OUTn
(where n indicates a value from
1
to 4 ), from left to right.
The setting is
0
or
1
.
0 : High‑impedance
1
: ON
5
Monitor voltage value
VMA
: Voltage monitor value for the power supply A circuit.
VMB : Voltage monitor value for the power supply B circuit.
The zero decimal point’s position is fixed using zero suppression.
6
Voltage error alarm results
OK : The monitor voltage (
5
) error relative to the output voltage setting
(
1
) falls within the normal range relative to the voltage error alarm
setting (
8
, p. 14).
NG : The monitor voltage (
5
) error relative to the output voltage setting
(
1
) indicates an error relative to the voltage error alarm setting (
8
,
p. 14).