Hioki RM3542-50, Инструкция по эксплуатации

Страница: 50 / 234

4.2 Setting Pre-Measurement Delay
44
This setting specifies the delay between trigger signal input and the start of measurement.
Adjust this setting to delay measurement until the measurement value has time to stabilize, so that
even if the sample is connected after triggering, measurement starts only after the specified delay.
The delay can be set by two methods, as follows.
4.2 Setting Pre-Measurement Delay
The DELAY1 setting is common to all ranges.
The default setting is 0 ms (corresponding to trigger signal input
at the same time as probe contacts become stable).
Setting DELAY1 affects measurements in all ranges.
Set DELAY1
Adjust this setting to allow for
probe contact mechanical
stabilization.
Set DELAY2 to the time needed for stabilization after measure-
ment current is applied, such as may be required for inductive
components.
The setting affects only the selected range.
The default setting is 0 ms (corresponding to resistance mea-
surement of non-inductive components).
Set DELAY2
Adjust this setting to allow for
stabilization of the measurement
sample.
DELAY1 and DELAY2 Timing Chart
* Internal delay is provided to suit purely resistive (non-reactive) measuring objects,
and is different for each measurement range.
Acquisition
Stable Contact
Internal
Probe Contact
Condition
Start
TRIG
Measurement
Current
Acquisition of
Measurement
value
End of
Measurement
EOM