Hioki RM3542-50, Инструкция по эксплуатации

Страница: 142 / 234

9.7 Message Reference
136
(3) Synchronization Commands
(4) Status and Event Control Commands
Set the OPC bit of SESR When Finished All Pending Operations
Syntax
Command
∗
OPC
Description
Sets the OPC (bit 0) of the Standard Event Status Register (SESR) when the commands
transmitted prior to the
∗
OPC
commands of all the commands have finished processing.
Respond to output queue with ASCII 1 when all pending operations have fin-
ished
Syntax Query
Response
∗
OPC?
1
Description
Responds with ASCII 1 when the commands transmitted prior to the
∗
OPC
commands of
all the commands have finished processing.
Execute continuous command after command processing
Syntax Command
∗
WAI
Description The instrument waits until all prior commands finish before executing any subsequent
commands.
Note
The
∗
WAI
command is supported because it is defined in IEEE 488.2-1987, but because
all device-specific commands are sequential types, this command has no actual effect even
if the
∗
WAI
command is used.
Clear the Status Byte and Related Queues (Except the Output Queue)
Syntax
Command
∗
CLS
Description
Clears the event status registers. The Status Byte Register bits corresponding to the event
status registers are also cleared. (SESR, ESR0, ESR1)
Note
The output queue is unaffected.
The Output Queue, Enable Register and the Status Byte MAV
(bit 4) are unaffected.