Hioki PR8111, Инструкция по эксплуатации

Страница: 19 / 44

2.2 Loading Recording Paper
15
1
Loading Roll Recording Paper
2
Pen lever
1
Round
holes
Chart holder
Oval holes
3
1
Turn on the POWER switch.
2
Set the pen lever to the CHART SET (top)
position and lock the lever in place by moving
it to the left.
The platen will be raised, and the pens will auto-
matically move to the far right.
3
Load the recording paper into the chart holder
with the round holes on the left and the oval
holes on the right.
4
Open the chart cover, pass the top of the
recording paper through the opening, and pull
the top edge through.
5
Align the paper so that the sprockets engage
the round holes on its left edge.
6
In the same way, align the paper so that the
sprockets engage the oval holes on its right
edge.
7
Close the chart cover.
8
Set the pen lever to the UP (middle) position.
The platen will be lowered.
Chart cover
5,6
Sprockets
4
7
Lower the START/STOP/FEED switch to the FEED
position to feed the paper and verify that it has been
properly loaded. You can press and hold the switch in
the
FEED position for at least 2 seconds to increase
the feed speed.
8
„
Remaining recording paper
The amount of recording paper remaining (in cm) is indicated on the left edge of the paper.
Red marks will appear on the right side of the paper when there is only about 100 cm of paper left.