Hioki MR8740, Инструкция по эксплуатации

Страница: 130 / 424

6.1 Reading Measurement Values (Using the A/B Cursors)
118
• Time difference, frequency and potential difference (and when scaling is enabled, scaling values)
can be read as numerical values using the A/B cursors on the Waveform screen. The cursors also
allow specifying the calculation and X-Y synthesis range.
• When displaying the X-Y waveform, the A/B cursors can be used to read the measurement val-
ues. Also with a split screen, A/B cursors can be used separately in the graphs to read the poten-
tial difference between the A and B points.
6.1 Reading Measurement Values (Using the A/
B Cursors)
A/B Cursor Settings
To open the screen: Right-click and select [DISP]
→
Waveform screen
→
Left-click [AB CSR]
→
A/B cursors
settings window
1
Left-click the [AB CSR] icon.
Left-click the [AB CSR] icon on the top right of
the Waveform screen.
2
Select the Cursor Type. Select
Move the flashing cursor to the [A/B Cursosrs]
item and select it.
3
Select the movement target for the A/B
cursors Select
Move the flashing cursor to the [Kind] item and
select it.
4
Select the measurement target channel
(
[Subject CH] ) for A and B
Select
Move the flashing cursor to the [A] or [B] item
and select it.
5
Move the A/B cursors
If you click while the mouse cursor is in the
Waveform screen, the A/B cursors move to that
position. Furthermore, you can also move the A
or B cursor by dragging the A or B cursor mark
on the Waveform screen while holding down the
left button of the mouse.
Off A/B cursors are not used.
div Move in horizontal axis (time axis) direction (X
axis for X-Y synthesis)
Range Move in vertical axis (voltage axis) direction (Y
axis for X-Y synthesis)
Trace Trace waveform data.
A Use only cursor A.
A-b Use A/B cursors but move only cursor A.
a-B Use A/B cursors but move only cursor B.
A&B Move both cursor A and cursor B together.
ALL Shows measurement values for all channels.
(When cursor type is
[Trace] or [Range] )
Ch1 to
Ch16 Show measurement values in selected channels
out of Ch1 - Ch16 (for 1, 2, 4, 8, 16 screens).
Gr1 to
Gr8 Specify X-Y synthesis for Gr1 to Gr8 (for X-Y
screen)
Analog
Ch
↔
Calc
Ch
When there is data on which waveform calculation
has been performed, the cursor target is switched
by analog channel and waveform calculation data.
1
2
3