Hioki Memory HiCorder MR6000, Инструкция по эксплуатации, Страница: 354 / 392

348
External Input and Output
15.1 External Input and Output
External input (IN1), (IN2)
Externally inputting signals can start and stop measurement as well as save data. In factory default
settings, the START signal is assigned to the IN1 terminal, and the STOP signal to the IN2 terminal.
How to input signals
1
Connect each of the IN1, IN2, and GND terminals to an external signal-outputting device with
wires.
See “2.5 Connecting the External Control Terminals” in the Quick Start Manual.
2
> [System] > [External terminal]
3
3
Tap the [IN1] and [IN2] boxes in the [External In] area in turn, and then from the list, choose
an action performed when an input signal is inputted.
START Starts a measurement.
STOP Stops the measurement (post-measurement processes such as numerical calculations
and automatic saving are performed).
START/STOP Starts a measurement when the low-level signal is inputted; stops the measurement
when the high-level signal is inputted.
SAVE Saves data on the specified conditions into a storage device that is specified in ( [Status]
> [Save] > [Save key operation] > ) [Quick] .
ABORT Forcibly terminates the measurement. (No post-measurement processes such as
numerical calculation or automatic saving are performed. However, the instrument
automatically saves a waveform file that contains data acquired until the forcible
termination).
EVENT Puts on an event mark.
The event marks are put on the waveform screen.
You can put event marks by pressing the START key during measurement.
HIOKI MR6000A966-03