Hioki Memory HiCorder MR6000, Инструкция по эксплуатации, Страница: 11 / 392

5
Setting Measurement Conditions
1.2 Setting Measurement Conditions
You have to set conditions required for measurement, such as the sampling rate ( [Sampling] ) and
recording length ( [Shot] ).
> [Status] > [Condition]
7
1
3
6
8
5
2
4
1
Enter a comment in the [Title comment] box.
Number of characters that can be entered: up to 40
2
Tap the [Sampling] box, and then choose a sampling rate from the list.
See “Sampling rate setting guideline” (p. 7).
200 MS/s  , 100 MS/s , 50 MS/s , 20 MS/s , 10 MS/s , 5 MS/s , 2 MS/s , 1 MS/s ,
500 kS/s , 200 kS/s , 100 kS/s , 50 kS/s , 20 kS/s , 10 kS/s , 5 kS/s , 2 kS/s , 1 kS/s ,
500 S/s , 200 S/s , 100 S/s , 50 S/s , 20 S/s , 10 S/s , 5 S/s , 2 S/s , 1 S/s
The instrument can measure signals at a sampling rate of 200 MS/s even with several modules other than
Model U8976 installed together. However, the data refresh rate does not exceed the maximum sampling rate
of each module.
When the real-time waveform calculation (Model MR6000-01 only) is set to
[On]
, you cannot choose a
sampling rate of 200 MS/s.
When the real-time saving is set to
[On]
, due to the combination of the number of channels to be used and
save destinations, the maximum sampling rate that can be set varies as follows:
Number of channels to be used
Maximum sampling rate that can be chosen
SSD HDD
USB flash drive
SD Card
FTP transmission
1 channel to 2 channels 20 MS/s 10 MS/s 5 MS/s
3 channel to 4 channels 10 MS/s 5 MS/s 2 MS/s
5 channel to 8 channels 5 MS/s 2 MS/s 1 MS/s
9 channel to 16 channels 2 MS/s 1 MS/s 500 kS/s
17 channel to 32 channels 1 MS/s 500 kS/s 200 kS/s
Only if the following Hioki-designated options are used, the real-time saving operation with the instrument is
guaranteed:
• Model U8332 SSD Unit

Model U8333 HD Unit
• Model Z4006 USB Drive

Model Z4001 and Model Z4003 SD Memory Card
Measurement Method
HIOKI MR6000A966-03