Hioki IM7580, Инструкция по эксплуатации

Страница: 45 / 340

37
Setting Basic Settings of Measurement Conditions
3.2.5 Setting the Measurement Frequency
Sets the frequency of the signal applied to the test sample. The value of the measurement
frequency level may change according to the sample which is being tested.
1
6
3
2
1
Press [SETUP] .
2
Press [BASIC] tab.
3
Press [FREQ] .
4
5
Input method can be switched
between [DIGIT] and [10-KEY] .
When setting with

/

(each digit)
4
Set the frequency with

/

or the numeric
keypad.
Settable range 1 MHz to 300 MHz
When setting with

/

(each digit)
Holding down a digit key changes the value continuously.
Settable range 1 MHz to 300 MHz
[×10]
Sets the measurement frequency to 10×.
[/10] Sets the measurement frequency to
1/10×.
4
5
To set the frequency with the
numeric keypad
To set the frequency with the numeric keypad
Changing the unit: M (mega)/ k (kilo)
[C] Repeats the input.
• Instrument key is enabled if a numerical value is input.
• Frequency is set on pressing the instrument key.
• If the value is set to more than 300 MHz:
The value is automatically set to 300 MHz.
• If the value is set to less than 1 MHz:
The value is automatically set to 1 MHz.
5
Press [EXIT] to close the measurement frequency
setting screen.
6
Press [EXIT] to close the advanced settings
screen.
3
LCR Function