Hioki BT5525, Инструкция по эксплуатации, Страница: 86 / 215

86
External Input and Output Terminals and Signals
Signal functions
Isolated power supply
Pin number Signal name
EXT. I/O MODE switch (NPN/PNP) setting
NPN PNP
8 ISO_5V Isolated power 5 V Insulated power supply −5 V
9, 27 ISO_COM Isolated power supply common
Input signal
Pin number Signal name Function
1 START Starts a test, and generates output voltage.
20 STOP Ends a test, and shuts down output voltage.
3 INTERLOCK Cancels the interlock state.
The interlock state is canceled while the signal is at the same potential
(ON) as ISO_COM.
Placing the signal in the open (OFF) state triggers the interlock,
preventing testing from starting.
The test is stopped when it turns OFF during the test.
See “2.6 Shutting Down the Output of the Instrument (Interlock
Function)” (p. 32).
4, 5, 22, 23 LOAD0 to LOAD3 Selects the number of the panel to be loaded.
6 LOAD_VALID Executes the panel load.
[INFO:002 Panel loading...] is displayed during panel load and does
not accept any key input.
Output signal
Pin number Signal name Function
30 PASS Outputs when the comparator judgment is PASS.
11 UPPER FAIL Outputs when the comparator judgment is UPPER FAIL.
12 LOWER FAIL Outputs when the comparator judgment is LOWER FAIL.
29 C_CHECK_FAIL Outputs when the contact check judgment is FAIL.
13 BDD Outputs when the BDD count is 1 or more.
28 TEST Outputs during a test.
31 VON Outputs when the voltage monitor value is within
±
10% of the set
voltage value.
10 SYSTEM_ERR Outputs when the following errors occur.
• When an internal temperature error occurs
• When a fan error occurs
• When a model information error occurs
• When a setting backup error occurs
EXT. I/O input and output signals cannot be used while the measurement conditions are being
changed inside the instrument.
HIOKI BT5525A961-00