Hioki 9603-01, Инструкция по эксплуатации

Страница: 20 / 32

12
_____________________________________________________________________________________________
4.2 Command Reference
______________________________________________________________________________________________
4.2.1 Command Reference Explanation
4.2.2 Specific Commands
S
S S
Syyyyn
nn
nttttaaaaxxxx
:DATAout:ITEM:EXTernalin <NR1>
<NR1> = 0 - 7
Example Example Example Example
":DATAOUT:ITEM:EXTERNALIN 7"
As the default output items to the
floppy disk drive or printer for external
signal input unit measurement, specify
EXTA, EXTB, PM.
F
F F
Fu
uu
un
nn
nc
cc
cttttiiiio
oo
on
nn
n
Sets the output item for the
measurement value with the 9603-01 to
FDD or printer.
The item is set as shown below by
setting bits, to specify a single
numerical value.
E E E Errrrrrrro oo orrrr
Execution error / If the setting data is
out of the range.
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
data − − − − − PM EXTB EXTA
4.2 Command Reference
::::C C C Co oo om m m mm m m maaaan nn nd dd d
Indicates functions of message reference
NOTE NOTE NOTE NOTE
"( )", "< >" marks should not be input.
S
S S
Syyyyn
nn
nttttaaaaxxxx
: Indicates the command syntax.
< << < > >> >
: (Data portion)
Indicates the data format for a
command that includes data.
<NR1>= integer data
R
R R
Re
ee
essssp
pp
po
oo
on
nn
nsssse
ee
e
ssssyyyyn nn nttttaaaaxxxx
: Indicated only for commands for
which a response message is returned.
Example Example Example Example
: Shows a simple example illustrating
the usage of the command. All
transmissions are indicated in "short
form."
F
F F
Fu
uu
un
nn
nc
cc
cttttiiiio
oo
on
nn
n
: Describes the function of the
command.
N
N N
No
oo
otttte
ee
e
: Describes points that require special
attention when using the command.
E E E Errrrrrrro oo orrrr
: Indicates the what kinds of errors
might occur.
:DATAout:ITEM:EXTernalin
Sets the output item for the measurement value by using the 9603-01.
This section explains the commands unique to the 9603-01 EXTERNAL
SIGNAL INPUT UNIT.