Hioki 8860-50, Инструкция по эксплуатации

Страница: 142 / 490

5.5 Verifying and Setting All Channels from a List
130
Measurement modes for which zero adjustment does not apply
• The [Temp] mode of the Model 8937 Voltage/Temp Unit
• Model 8939 Strain Unit
• Model 8960 Strain Unit
• Modes other than [Voltage] and [Current] of the Model 8940 F/V Unit
• Model 8958 16-Ch Scanner Unit
Input Channel Settings List: [All Ch] Page
To open the screen: Press the
SET
key

Select with the
SUB MENU
keys

Select the [All Ch] page
with the
SHEET/PAGE
keys
Executes for all channels at once.
Using the CURSOR keys, move the cursor to the [Ch] column.
• To set each channel:
Select F1 [All Settings] and set from the dialog. (Each setting can be made
when the cursor is moved to the setting item.) Setting choices are the same
as on the
[One Ch] page. Range and zero position can be set by the
RANGE/POSN knobs. (Zero position can also be set by Jog and Shuttle.)
See "5.1 Analog Channel Settings" (p. 116)
• To copy settings from one channel to another:
Select F2 [Copy] .
Adjusts the zero position
settings of all channels at
once (p. 131).
Display contents can be
switched.
(Shared and unique settings
for each input module)
This mark indicates
settings are valid.
Indicates presence of a waveform and
display color setting (p. 171)
Available when using the
Model 8939 or 8960
Strain Unit (p. 130)
To execute zero adjustment
To simultaneous zero-adjust all input modules
To correct internal bias of an input module in order to set the reference potential
of the instrument to zero volts.
Move the cursor to the [Zero-Adjust] button, and select F1 [Execute] .
See "3.11.17 Executing Zero Adjustment" in the Input Module Guide
Zero adjustment is executed on all channels except as follows.
To execute auto balance (Model 8939 Strain Unit only)
Move the cursor to the [Auto-Balance] button, and select F1 .
Only channels in the 8939 Strain Unit are affected.
See "3.11.19 Executing Auto-Balance" in the Input Module Guide