Hioki 3504-40 C HiTester, Инструкция по эксплуатации

Страница: 134 / 292

7.4 About Measurement Times
128
Measurement times differ depending on the measurement conditions. Refer to
the following values.
Analog Measure-
ment Signal
INDEX
The output time (
T3
) for an analog measurement signal (INDEX) can be
obtained by the following equation.
T3 = (1 or 2) + 3
(HOLD range contact check: OFF, trigger simultaneous output function: disabled)
1. No request for self calibration
(Allowable tolerance:
±
5%
±
0.3 ms)
2. Request for self calibration
3. Contact check evaluation time (Only for 3504-60)
Calculation times differ depending on the execution of the contact checks.
* When the contact check setting is at “bEForE”, “both” the analog measurement
time will be delayed because automatically after contact check, the measure-
ment will start only after the wait time for the trigger simultaneous output func-
tion has been activated.
The above values are the initial values of the wait time settings. They are for
reference only. The actual value will be 5.0 ms + wait time of the trigger simul-
taneous output function.
A wait time for trigger synchronous output function will be decided according to
the following table.
As for Range 9 and 10, when 120 Hz, 40 ms will be added to the wait time of
Range 1 to 8, when 1 KHz, 3 ms will be added to the wait time.
7.4 About Measurement Times
• All of the values are reference values. Note that they may differ depending
on the conditions of use.
• A wait of 350 ms is included when the frequency, level, and range change.
Measurement Frequency
Measurement Speed
FAST (ms) NORM (ms) SLOW (ms)
120 Hz 8.3 33.3 133.3
1 kHz 1 4 24
Measurement Frequency
Measurement Speed
FAST (ms) NORM (ms) SLOW (ms)
120 Hz 24.1 41 141
1 kHz 3.7 5.7 26.9
Measurement Frequency
Measurement Speed
BEFORE (ms) AFTER (ms) BOTH (ms)
120 Hz 15.0 * 5.0 20.0 *
1 kHz 7.0 * 5.0 12.0 *
Wait time default setting
Measurement
Frequency
Range
1 to 8
Range
9, 10
120 Hz 10 ms 10 ms + 40 ms
1 kHz 2 ms 2 ms + 3 ms